>
Desciption |
PGS Unit (Back & Blinde Unit) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing (A).
(Refer to Body - "Crach Pad")
3.
Remove the glove box housing connector (A).
4.
Remove t ...
8LR Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Mode Control Actuator Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the
mode control actuator based on the signal of the A/C control unit. ...