After a jump start from a good battery, run the engine for 20-30 minutes at idle
or driving the vehicle before it is shutoff. Vehicle may not restart if you shut
it off before the battery had chance to adequately recharge.
WARNING - Recharging battery
When recharging the battery, observe the following precautions:
- The battery must be removed from the vehicle and placed in an area with
good ventilation.
- Do not allow cigarettes, sparks, or flame near the battery.
- Watch the battery during charging, and stop or reduce the charging rate
if the battery cells begin gassing (boiling) violently or if the temperature
of the electrolyte of any cell exceeds 120°F (49°C).
- Wear eye protection when checking the battery during charging.
- Disconnect the battery charger in the following order.
1. Turn off the battery charger main switch.
2. Unhook the negative clamp from the negative battery terminal.
3. Unhook the positive clamp from the positive battery terminal.
WARNING
- Before performing maintenance or recharging the battery, turn off all
accessories and stop the engine.
- The negative battery cable must be removed first and installed last when
the battery is disconnected.
- Operation related to the battery should be done at an authorized EQUUS
dealer.
CAUTION
- Keep the battery away from water or any liquid.
- The battery is in the trunk, so you should be careful when you load a
container filled with liquid into the trunk.
- For your safety, use a genuine HYUNDAI approved battery when you replace
the battery.
Your vehicle has a maintenance-free, calcium-based battery.
If the battery becomes discharged in a short time (because, for example,
the headlights or interior lights were left on while the veh ...
Items should be reset after the battery has been discharged or the battery has
been disconnected.
Auto up/down window
Sunroof
Driver position memory system
Trip computer
Climate control ...
See also:
G Sensor Schematic Diagrams
Circuit diagram
1.
G-sensor connector
2.
G-sensor terminal function
NoFunction1Signal2Ground3Power(5V)
3.
Circuit diagram ...
Water pump Components and Components Location
Components
1. Drive belt2. Drive belt tensioner3. Drive belt idler4. Water pump pulley5. Water pump6. Water pump gasket
...
Head Up Display Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the head up display bezel (A).
3.
Remove the instrument cluster.
(Refer to Indicators And Guages - "Instrument Cluster") ...