>
Hyundai Equus Manuals

Hyundai Equus: Rear Door Trim Repair procedures - Rear Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Rear Door Trim Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Trim Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Be careful not to scratch the door trim and other parts.
1.
Detach the clip, then remove the frame inner cover (A).

2.
Using a screwdriver or remover, remove the rear door pull handle cap (A).

3.
Remove the inside handle cover (A).
4.
Loosen the door trim (B) mounting screws, Release the clips that hold the door trim.

5.
Push the hook, then remove the inside handle cable cage (A).

6.
Remove the rear door inside handle cage (A).

7.
Disconnect the power window connector (A), then remove the door trim.

8.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.
    Rear Door Trim Components and Components Location
    Component Location 1. Rear door trim ...

    Rear Door Inside Handle Repair procedures
    Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Disconnect the rear door inside handle lamp connector (A). 3. After loosening the mounting screws, th ...

    See also:

    Fuel Pressure Sensor (FPS) Troubleshooting
    Fail-Safe Mode ItemFail-SafeDuty (%)85     If the fuel pressure sensor malfunctions, it enters fail safe mode. This means that the fuel pressure rises to match the increasi ...

    Instrument Cluster Components and Components Location
    Components Connector Pin Information No.DescriptionNo.Description1Aig bag +21-2-22Speaker +3Rheostat down switch23Speaker -4Rheostat up switch24-5-25Vehicle speed 4P output6Oil pressure26R Output7 ...

    A/C Pressure Transducer Repair procedures
    Inspection 1. Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”. 2. Inspect the voltage value whether it is sufficient to be regular value or ...

    Categories

    Hyundai Equus Manuals


    © 2011-2025 Copyright www.heqmanual.com