>
Removal |
Take care not to scratch the crash pad and related parts. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the LCD monitor bezel (A) from the front seat back. |
3. |
Remove the front seat back cover.
(Refer to Body - "Front Seat Back Cover") |
4. |
Remove the rear LDC monitor after removing the connetors (A) and bolts (B). |
Installation |
1. |
Install the rear LCD monitor to the rear seat. |
2. |
Install the LCD monitor bezel.
|
Master Cylinder Components and Components Location
Components
1. Reservoir cap2. Reservoir3. Grommet4. Cylinder pin5. Retainer6. Primary piston assembly7. Secondary piston assembly8. Master cylinder body
...
Heated Oxygen Sensor (HO2S) Specifications
Specification
A/F Ratio (x)Output Voltage(V)RICH0.6 ~ 1.0LEAN0 ~ 0.4
ItemSpecificationHeater Resistance (x)Approx. 9.0 [21°C(69.8°F)]
...
Trailing Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...