>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim.
(Refer to Body - "Front door trim") |
3. |
Disconnect the rear door side curtain connector (A). |
4. |
Remove the rear door side curtain assembly (A) after loosening the screws. |
5. |
Remove the rear door side curtain motor (A) after loosening the screws. |
Installation |
1. |
Install the rear door side curtain assembly. |
2. |
Connect the connector and install the front door trim. |
Solenoid Valve Description and Operation
Description
Four air spring solenoid valves (‘-’ control) and one
ambient solenoid valve are embedded inside this solenoid valve block as
shown in the circuit diagram below. When connecting the ...
Fuel Pressure Sensor (FPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
Removal
1.
Turn i ...
Blind Spot Detection Unit Schematic Diagrams
Circuit Diagram
...