Adjustment |
1. |
Driving the vehicle in a circle at less than 8km/h 3 times or until the compass heading appears. |
2. |
Driving in a circle in right-handed direction and opposite
direction are possible, and if the calibration is completed, the compass
heading will appear. |
3. |
Keep driving in a circle until a commpass heading appears. |
1. |
Determine the desired zone number based upon your current location on the zone maps. |
2. |
Press and hold the Feature Control button for more than 6 but
less than 9 seconds, the current zone number will appear on the display
(B). |
3. |
Pressing and holding the feature control button (A) again
will cause the numbers to increment (Note: they will repeat …13, 14,
15, 1, 2,..). Releasing the button when the desired zone number appears
on the display will set the new zone. |
4. |
Within about 5 seconds the compass will start displaying a compass heading again. |
1. |
Press and hold the feature control button (A) for more than 9
seconds. When the compass memory is cleared, a "C" will appear in the
display (B). |
2. |
To calibrate the compass, drive the vehicle is 2 complete circles at less than 8 KPH (5 MPH). |
Emergency starting
Connect cables in numerical order and disconnect in reverse order.
✽ NOTICE
Your vehicle has a battery in the trunk compartment, but when you jump start
your vehicle, use the jumper termi ...
Components and Components Location
Component
...
Repair procedures
Inspection
Initialization and diagnosis sequence by using diagnostic equipment
Below content summarize the procedure for A/S using Diagnostic equipment
Download Parameter
1.
Select "AFLS" menu ...