Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the connector from the front bumper cover.
(Refer to Body - "Front Bumper Cover") |
3. |
Pull out the sensor (A) by opening the sensor holder out. |
4. |
Disconnect the connector from the sensor. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the connector from the rear bumper cover.
(Refer to Body - "Rear Bumper Cover") |
3. |
Pull out the sensor (A) by opening the sensor holder out. |
4. |
Disconnect the connector from the sensor. |
Installation |
1. |
Install the senosr after connecting the connector. |
2. |
Connect the negative (-) battery terminal. |
1. |
Install the senosr after connecting the connector. |
2. |
Connect the negative (-) battery terminal. |
Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 7,500
miles (12,000 km) or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When r ...
Auto Head lamp leveling Unit Repair procedures
Removal
1.
Remove the head lamp leveling unit linkage (A) from trailing arm.
2.
Loosen the mounting bolts (3EA) of automatic head lamp leveling unit assembly.
Tightening torque :
3 ~ 5 N.m ...
Sunroof Motor Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console then remove the sun roof motor
mounting screws (3EA). And then remove the sunroof motor (A) after ...