>
OFF
To turn off the engine, press the Engine Start/Stop Button with the Engine Start/Stop Button in the ON position and the shift lever in P(Park). When you press the Engine Start/Stop Button without the shift lever in P(Park), the Engine Start/Stop Button does not turn to the OFF position, but turns to the ACC position.
✽ NOTICE
When you turn off the engine, the vehicle should be stopped.
WARNING - Emergency situation
In an emergency situation while the vehicle is in motion, you are able to turn the engine off and to the ACC position by pressing the Engine Start/Stop Button for more than 2 seconds or 3 times successively within 3 seconds. If the vehicle is still moving, you can restart the engine without depressing the brake pedal by pressing the Engine Start/Stop Button with the shift lever in the N (Neutral) position.
ACC(Accessory)
Press the Engine Start/Stop Button when the button is in the OFF position without depressing the brake pedal.
The electrical accessories are operative. If you leave the Engine Start/Stop Button in the ACC position for more than 1 hour, the battery power will turn off automatically to prevent the battery from discharging.
ON
Press the Engine Start/Stop Button while it is in the ACC position without depressing the brake pedal.
The warning lights can be checked before the engine is started. Do not leave in the ON position for a long time if the engine is not running to prevent battery discharge.
START
To start the engine, press the brake pedal and press the Engine Start/Stop Button with the shift lever in the P(Park) or the N(Neutral) position.
For your safety, start the engine with the shift lever in the P(Park) position.
✽ NOTICE
WARNING
Components and Components Location
Component Location
1. Sunroof2. Sunroof switch3. Sunroof motor & controller
...
Lane Departure Warning System (LDWS) Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the LDWS unit cover (A).
3.
Remove the LDWS unit connector (A).
4.
Remove the front side of roof trim to remove the L ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...