>
(1) Position light
(2) Headlight (High)
(3) Headlight (Low)
(4) Front side marker light
(5) Front turn signal light
(6) Front fog light
1. Open the hood.
2. Disconnect the negative battery cable.
3. Push the top of the fastener to remove the cover.
4. Remove the cover.
5. Pull out the cover (if equipped).
6. Insert a screw driver into the hold (1) and lift up the screw driver while pulling
out the cover (2).
7. Remove the fastener and screw under the wheel arch.
8. Pull out the bumper.
9. Remove 4 fasteners on the grille and the bolt.
10. Remove the front bumper.
11. Be careful not to break up the clips on the inside of the front bumper.
12. If you want to replace the right side head lamp, remove the bolts then remove the air cleaner.
13. Remove the mounting bolts.
14. Pull the headlight assembly out to the front of the vehicle.
15. Remove the clips.
16. Disconnect the power connector (s) from the back of the headlight assembly.
WARNING - HID Headlight low beam (if equipped)
Do not attempt to replace or inspect the low beam (XENON bulb) due to electric shock danger. If the low beam (XENON bulb) is not working, have your vehicle checked by an authorized EQUUS dealer.
CAUTION
If your vehicle is equipped with High Intensity Discharge (HID) headlights, these headlights contain mercury. So if you need to have your vehicle disposed, you should remove the HID Headlights before disposal. The removed HID headlights should be recycled, re-used or disposed as hazardous waste.
✽ NOTICE
HID lamps have superior performance vs. halogen bulbs. HID lamps are estimated by the manufacturer to last twice as long or longer than halogen bulbs depending on their frequency of use. They will probably require replacement at some point in the life of the vehicle. Cycling the headlamps on and off more than typical use will shorten HID lamps life. HID lamps do not fail in the same manner as halogen incandescent lamps. If a headlamp goes out after a period of operation but will immediately relight when the headlamp switch is cycled it is likely the HID lamp needs to be replaced. HID lighting components are more complex than conventional halogen bulbs thus have higher replacement cost.
Headlight (bulb type), front turn signal, position, side marker and fog light bulbs
If the light bulb is not operating, have the vehicle checked by an authorized EQUUS dealer.
Headlight bulb
WARNING - Halogen bulbs
17. Remove the headlight bulb cover by turning it counter clockwise.
18. Disconnect the headlight bulb socket connector.
19. Unsnap the headlight bulb retaining wire by depressing the end and pushing it
upward.
20. Remove the bulb from the headlight assembly.
21. Install a new headlight bulb and snap the headlight bulb retaining wire into
position by aligning the wire with the groove on the bulb.
22. Connect the headlight bulb socket connector.
23. Install the headlight bulb cover by turning it clockwise.
24. Connect the power connector(s) to the back of the headlight assembly.
25. Reinstall the headlight assembly to the body of the vehicle.
✽ NOTICE
Always have the headlight aiming adjusted after an accident or the headlight assembly is reinstalled at an authorized EQUUS dealer.
CAUTION
If the headlight (Low) is not operating, have the vehicle checked by an authorized EQUUS dealer.
Turn signal light - bulb type
If the light bulb is not operating, have the vehicle checked by an authorized EQUUS dealer.
Position light, Front fog light
If the light bulb is not operating, have the vehicle checked by an authorized EQUUS dealer.
Troubleshooting
Troubleshooting
Ignition System
SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition c ...
Highway driving
Tires
Adjust the tire inflation pressures to specification. Low tire inflation pressures
will result in overheating and possible failure of the tires.
Avoid using worn or damaged tires which m ...
Description and Operation
Description
Tread Lamp
-
Tire Under Inflation / Leak Warning.
1.
Turn on condition
A.
When tire pressure is below allowed threshold
B.
When rapid leak is detected by the sensor.
2 ...