Hyundai Equus: Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these steps:
1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has
been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position
the handheld transmitter 1 to 3 inches away from the HomeLink® surface.
3. Press and hold the handheld transmitter button.The HomeLink® indicator light
will flash, first slowly and then rapidly.
4. When the indicator light begins to flash rapidly, release both buttons.
5. Press and hold the just-trained HomeLink® button and observe the red Status Indicator
LED. If the indicator light stays on constantly, programming is complete and your
new device should activate.
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, ho ...
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash-after 20 seconds.
2 ...
See also:
Immobilizer system
The immobilizer system protects your vehicle from theft. If an improperly coded
key (or other device) is used, the engine’s fuel system is disabled.
When the Engine Start/Stop Button is in the ON p ...
Sedan Interior
Interior A
Front inner pillar tooling hole (O9)Cowl cross bar mounting hole (O11)Front door checker mounting hole (O11)Side sill inner reinforcement tooling hole (O7)Seat belt height adjuster upp ...
Specifications
Specification
Air Conditioner
ItemSpecificationCompressorType7VSX18Oil type & CapacityPAG 120± 10cc (4.1±0.3oz.)Pulley typeAround rubber damperDisplacement180cc/revCondenserHeat rejection18,50 ...