>

Hyundai Equus: Erasing HomeLink® buttons - Mirrors - Features of your vehicle - Hyundai Equus 2009-2025 Owners ManualHyundai Equus: Erasing HomeLink® buttons

Individual buttons cannot be erased. However, to erase all three programmed buttons:

1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash-after 20 seconds.
2. Release both buttons. Do not hold for longer than 30 seconds.

The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above.

FCC ID: NZLZTVHL3 IC: 4112A-ZTVHL3

    Reprogramming a single HomeLink® button
    To program a new device to a previously trained HomeLink® button, follow these steps: 1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has been completed. 2. When the ...

    This device complies with Part 15 of the FCC Rules.
    Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may c ...

    See also:

    Center Fascia Panel Repair procedures
    Replacement [Center Fascia Upper Panel]     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with pr ...

    Drive belts
    Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if necessary. ...

    Heated Oxygen Sensor (HO2S) Troubleshooting
    Signal Waveform Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle Fig.3) Typical ...

    Categories

    Hyundai Equus Manuals


    © 2011-2025 Copyright www.heqmanual.com