>
The vehicle certification label attached on the driver’s side center pillar gives the vehicle identification number (VIN).
Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutra ...
Scheduled maintenance service
Follow Normal Maintenance Schedule if the vehicle is usually operated where none
of the following conditions apply.
If any of the following conditions apply, follow Maintenance Under Severe Usage
...
Trailing Arm Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Disconnect the trailing arm (A) from the rear axle by loosening ...