>

Hyundai Equus: Cylinder Block Components and Components Location - Cylinder Block - Engine Mechanical System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Cylinder Block Components and Components Location

Components

1. Cylinder block bank cover
2. Cylinder block bank cover gasket
3. Cylinder block rear cover
4. Cylinder block rear cover gasket
5. Separator
6. Drain plug
7. O-ring
8. Piston oil jet
9. Check valve
10. Cylinder block
11. Lower crankcase assembly
12. Snap ring
13. Piston pin
14. Piston
15. Connecting rod
16. Connecting rod bearing
17. Crankshaft pulley
18. Friction plate
19. Crankshaft sprocket
20. Key
21. Crankshaft
22. Crankshaft main bearing
23. Crankshaft center main bearing
24. Crankshaft adapter
25. Drive plate
26. Adapter plate
27. Crankshaft rear oil seal

    Cylinder Block
    ...

    Cylinder Block Repair procedures
    Disassembly Engine removal is required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors ca ...

    See also:

    Head Up Display Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower panel and then push the head u ...

    Automatic transmission fluid
    Automatic transmission fluid should not be checked under normal usage conditions. But in severe conditions, the fluid should be changed at an authorized EQUUS dealer in accordance to the scheduled ...

    Non-operating condition
    Driver's Attention The driver must be cautious in the below situations for the system may not assist the driver and may not work properly. - Curved roads, tollgates, etc. - The surrounding of ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com