Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and
detects the piston position of each cylinder which the CKPS can't
detect.
The CMPS is installed on engine head cover and uses a target
wheel installed on the camshaft. The Cam Position sensor is a
hall-effect type sensor. As the target wheel passes the Hall sensor, the
magnetic field changes in the sensor. The sensor then switches a signal
which creates a square wave.
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cab ...
Specification
ItemSpecificationOutput Voltage (V)High : 5.0VLow : 0.7VAir Gap (mm)0.2 ~ 2.0
...
See also:
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the throttle body and connect a vacuum pump to the nipple on the throttle body.
2.
Check the following points with applying ...
To Reset the Power Trunk
If the battery has been discharged or disconnected, or if the related fuse has
been replaced or disconnected, reset the Power Trunk as follows:
1. Move the shift lever to the P(Park) position.
2. ...
Good driving practices
Never move the gear shift lever from P (Park) or N (Neutral) to any other
position with the accelerator pedal depressed.
Never move the gear shift lever into P (Park) when the vehicle is in mo ...