Hyundai Equus: To Reset the Power Trunk
If the battery has been discharged or disconnected, or if the related fuse has been replaced or disconnected, reset the Power Trunk as follows:
1. Move the shift lever to the P(Park) position.
2. Close the trunk manually.
If the Power Trunk doesn't work properly after performing the above procedure, have the system checked by an authorized EQUUS dealer.
Power Trunk (if equipped)
(1) Power Trunk Main Control button
(2) Power Trunk Open button
(3) Power Trunk Close button
(4) Power Trunk Lock button
To open:
1. Make sure the shift lever is in P(Park).
2. Then do one o ...
Trunk Lid Control Button
When the trunk lid control button is ON (depressed), the power trunk can be controlled
with the power trunk main control button, power trunk open, close button, and the
smart key.
When this t ...
See also:
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negative ...
Side Airbag (SAB) Module Components and Components Location
Components
...
Line Pressure Control Solenoid Vale Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...