>

Hyundai Equus: Compressor Schematic Diagrams - Air Suspension System - Suspension System - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Compressor Schematic Diagrams

Circuit diagram
1.
Air compressor connector

[Motor power connector (A)]
[Exhaust valve connector (B)]
[Temperature sensor connector (C)]

2.
Air compressor terminal function
[Motor power]
Terminal
Function
1
Motor power
2
Motor ground

[Solenoid valve]
Terminal
Function
1
Solenoid valve control
2
Solenoid valve power

[Temperature sensor]
Terminal
Function
1
Temperature sensor power
2
Temperature sensor signal

3.
Circuit diagram

    Compressor Description and Operation
    Description The compressor operates in all events except the system air filling and two solenoid valves (referred to as reverse valve, on-off control, and normal open) are embedded. Air dryer ...

    Compressor Repair procedures
    Removal     • This system combines a sensor and electronic parts with mechanical components, so be careful not to subject the system to strong impacts. • If any pin ...

    See also:

    Rear Bumper Cover Components and Components Location
    Component Location 1. Rear bumper cover ...

    Engine Control Module (ECM) Repair procedures
    Removal     When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutra ...

    Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Categories

    Hyundai Equus Manuals


    © 2011-2025 Copyright www.heqmanual.com