>

Hyundai Equus: Solenoid Valve Schematic Diagrams - Air Suspension System - Suspension System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Solenoid Valve Schematic Diagrams

Circuit diagram
1.
Solenoid valve connector terminal

2.
Solenoid valve terminal function
Terninal
Function
1
Air spring valve FL
2
Ambiance valve
3
Air spring valve RR
4
Air spring valve RL
5
Solenoid valve power(12V)
6
Solenoid valve power(12V)
7
Pressure sensor ground
8
Air spring valve FR
9
Pressure sensor  signal
10
Pressure sensor  power

3.
Circuit diagram

    Solenoid Valve Description and Operation
    Description Four air spring solenoid valves (‘-’ control) and one ambient solenoid valve are embedded inside this solenoid valve block as shown in the circuit diagram below. When connecting the ...

    Solenoid Valve Repair procedures
    Removal     • Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts. (Refer to Air Suspension System - "Repair procedures ( ...

    See also:

    Resetting the Sunroof
    If the battery has been discharged or disconnected, or if the related fuse has been replaced or disconnected, reset the Sunroof as follows: 1. The Engine Start/Stop Button must be in the ON positio ...

    Muffler Repair procedures
    Removal 1. Disconnect the rear oxygen sensor (HO2S) connector (A) on LH and RH side. 2. Remove the front muffler (A) on LH and RH side. Tightening torque : 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m ...

    Repair procedures
    Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, and put a finger on t ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com