Hyundai Equus: Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time.
Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting.
Continue to press the Integrated HomeLink® Wireless Control System button (note
steps 2 through 4 in the Standard ...
Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these
steps:
1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has
been completed.
2. When the ...
See also:
Repair procedures
Refrigerant System Service Basics
Refrigerant Recovery
Use only service equipment that is U.L-listed and is
certified to meet the requirements of SAE J2210 to remove
HFC-134a(R-134a) from the ...
Thermostat Repair procedures
Removal and Installation
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
4.0~6.0N.m (0.4~0.6kgf.m, 3.0~4.4lb-ft)
2.
Remove the air duct, air intak hose and ...
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts. The purpose of the pretensioner is to make sure that the seat belts fit tightly
against the occup ...