>

Hyundai Equus: Trunk Lid Latch Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Trunk Lid Latch Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the trunk lid latch connector (A) and remove the trunk lid latch cable (B).
3.
After loosening the mounting bolts, then remove the trunk lid latch assembly (C).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure the trunk lid locks/unlocks and opens/closes properly.
Adjust the trunk lid alignment.
Make sure the connectors are connected in properly.
    Trunk Lid Latch Components and Components Location
    Component Location 1. Trunk lid latch ...

    Trunk Lid Key Holder Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    See also:

    Components and Components Location
    Component Location 1. Power seat memory unit (Driver)2. Memory power seat control switch (Driver)3. Passenger power seat control switch4. Outside mirror cintrol switch (Built in DDM)5. Rear right ...

    Theft-alarm system
    This system helps to protect your vehicle and valuables. The horn will sound and the hazard warning lights will blink continuously if any of the following occurs: - A door is opened without using t ...

    Input Speed Sensor Specifications
    Specifications x Type: Hall effect sensor x Specifications Operation condition (°C)°F((-)40~150)) -40~302Air gap(mm)in.1.3(0.0512)Output voltageHigh1.4Low0.7 ...

    Categories

    Hyundai Equus Manuals


    © 2011-2025 Copyright www.heqmanual.com