>
Replacement |
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Disconnect the front door inside handle lamp connector (A). |
3. |
After loosening the mounting screws, then remove the front door inside handle (B). |
4. |
Install in the reverse order of removal.
|
Cool and Warm Box Components and Components Location
Component Location
1. Cool & Warm Box Bracket2. Wire Harness3. Front Duct4. Cool & Warm Box Assembly5. Wire Harness6. Cool & Warm Box Partition7. Circuit Board Cover8. Circuit Board9. ...
Knock Sensor (KS) Schematic Diagrams
Circuit Diagram
...
Rear Hub - Carrier Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub .
Be care ...