>

Hyundai Equus: External AMP Repair procedures - Premium AVN System - Body Electrical System - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: External AMP Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Open the trunk, remove the right trunk trim.
(Refer to Body - "Trunk Trim")
3.
Remove the external amplifier after disconneting the connector (A) and loosening the mounting nuts (B).

Installation
1.
Install the external amplifier after connecting the connector.
2.
Install the right trunk trim.
3.
Connect the negative (-) battery terminal.
   
-
Make sure that the cables and connectors are plugged in properly.
-
Check the AVN system.
    External AMP Components and Components Location
    Components Connector Pin Information No.Connector AConnector BConnector C 1B (+)Right surround (+)right rear door (+)2B (+)Left surround (+)left rear door (+)3B (+)Rear right midrange/tweeter (+)R ...

    Center Control Panel (CCP) Components and Components Location
    Components ...

    See also:

    Inhibitor Switch Schematic Diagrams
    Circuit Diagram ...

    Drive belts
    Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if necessary. ...

    Knee Airbag (KAB) Module Repair procedures
    Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") ...

    Categories

    Hyundai Equus Manuals


    © 2011-2025 Copyright www.heqmanual.com