>

Hyundai Equus: Fluid Components and Components Location - Hydraulic System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Fluid Components and Components Location

Components Location

1. Oil injection hole
2. Oil level check plug
3. Oil drain piug

    Oil Pump Components and Components Location
    Components Location 1. Oil seal2. Reaction shaft3. Housing4. Cover5. O-Ring6. Reaction shaft7. Snap ring8. Needle bearing9. 8LR/B return spring10. 8LR/B piston ...

    Fluid Repair procedures
    Service Adjustment Procedure Oil level Check     A check of ATF level is not normally required during scheduled services. If an oil leak is found, perform the oil level chec ...

    See also:

    Cylinder Head Components and Components Location
    Components [RH] 1. Cylinder head cover2. Cylinder head cover oil seal3. Cylinder head cover gasket4. Exhaust CVVT assembly5. Exhaust camshaft, RH6. Intake CVVT assembly7. Intake camshaft, RH8. C ...

    Intake Actuator Description and Operation
    Description The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculat ...

    Side Impact Sensor (SIS) Description and Operation
    Description The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors whi ...

    Categories

    Hyundai Equus Manuals


    © 2011-2025 Copyright www.heqmanual.com