>
Hyundai Equus Manuals

Hyundai Equus: Fuel Filter Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Fuel Filter Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Filter Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line")
3.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
4.
Remove the sub fuel sender.
(Refer to Fuel Delivery System - "Sub Fuel Sender")
5.
Disconnect the suction hose (A).
6.
Remove the head assembly (C ) after removing the fixing hook (B).

7.
Disconnect the dual hose (A).

8.
Release the fixing hook, and then remove the free filter (A) and fuel pump motor (B).

9.
Remove the over pressure valve assembly (B) from the fuel filter after release the fixing hook (A).

Installation
1.
Install in the reverse order of removal.
    Sub Fuel Sender Repair procedures
    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Folding the rear seat cushion. 3. Remove the fuel pump ...

    Fuel Pump Motor Components and Components Location
    Components Pin NO.ItemDescription1Upper body3-phase coil power supply, fuel delivery, and sealing2Stator assemblyCreates an N pole and S pole flux to induce the rotor to turn.3rotor assemblyTorqu ...

    See also:

    Front Door Inside Handle Repair procedures
    Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Disconnect the front door inside handle lamp connector (A). 3. After loosening the mounting screws ...

    Receiver-Drier Repair procedures
    Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tightening torque : 2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft) ...

    Cylinder Block Repair procedures
    Disassembly Engine removal is required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors ca ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com