Hyundai Equus: Mode Control Actuator Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator Description and Operation
| Description |
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the
mode control actuator based on the signal of the A/C control unit.
Pressing the mode select switch makes the mode control actuator shift in
order of Vent > Bi-Level > Floor > Mix.
Temperature Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the
warm (Driver's side) ...
Mode Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...
See also:
Components and Components Location
Components Location
1. Fuel tank2. Fuel pump3. Sub fuel sender4. Fuel filter5. Over Pressure Valve (OPV)6. Canister7. Fuel tank air filter8. Fuel Pressure Sensor (FPS)9. Fuel Level Sensor ( ...
Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON’T remove the camshaft position se ...
Assist Door Module (ADM) Description and Operation
Description
1.
Assist Door Module (ADM)
(1)
Main features
ItemExplanationNotesInstallation location Passenger side door trimComponent configuration
1.
Embedded with CAN Communication IC
...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com