>
Inspection |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the front door trim.
(Refer to Body - "Front Door") |
3. |
Disconnect the motor connector from the motor. |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor. |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the rear door trim.
(Refer to Body - "Rear Door") |
3. |
Disconnect the motor connector from the motor. |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor.
[Satety Window] |
Light bulbs
WARNING - Working on the lights
Prior to working on the light, firmly apply the parking brake, ensure that
the ignition switch is turned to the LOCK position and turn off the lights to avoid
sudd ...
Fuel Pressure Control Valve Troubleshooting
Signal Waveform
...
Transmission Control Module (TCM) Schematic Diagrams
1. TCM Connector and Terminal Function
2. TCM Terminal Function
Connector
PinDescriptionPinDescription1Battery power48-2Battery power49-3Power(IG 1)5027 Brake control solenoid valve4Ground51-5G ...