Hyundai Equus: Rail Pressure Sensor (RPS) Schematic Diagrams

Rail Pressure Sensor (RPS) Troubleshooting

Signal Waveform ...

Rail Pressure Sensor (RPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ConditionOutput Voltage (V)Idle Approx. 1.21, ...

See also:

Water pump Repair procedures
Removal and Installation Water Pump 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) 2. Remove the air du ...

Power Steering Gear Box Repair procedures
Replacement 1. Drain the power steering fluid. 2. Remove the front wheel & tire. Tightening torque : 90.0 ~ 110.0 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft) 3. Loosen the bolt (A) ...

Fuel Filler Door Release Actuator Repair procedures
Inspection 1. Remove the trunk room left side trim. 2. Open the fuel filler door and remove the housing. (Refer to the BD group - "Exterior")     Do not reuse the fuel fill ...