Hyundai Equus: Sedan Rear Body
| Rear body |
|
|
|
| Roof panel rear corner | Side outer panel rear corner | Rear parkage tray panel tooling hole (O23) |
|
|
|
| Side outer panel rear corner | Tooling hole (14X10) | Tooling hole (O10) |
Sedan Interior
Interior A
Front inner pillar tooling hole (O9)Cowl cross bar mounting hole (O11)Front door checker mounting hole (O11)Side sill inner reinforcement tooling hole (O7)Seat belt height adjuster upp ...
Sedan Under Body
Under body
Projected dimensions
Tooling hole (O25)Front sub frame mounting pipe (O25)Tooling hole (O14)Front sub frame mounting pipe (O27)Tooling hole (O15)Tooling & paint drain hole (O6.6 ...
See also:
Cylinder Block Repair procedures
Disassembly
Engine removal is required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors ca ...
Over Pressure Valve (OPV) Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressu ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it with the lever
in the OFF position. The wipers will operate conti ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com