Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit") |
3. |
Separate the blower unit (A) from the heater unit (B) after loosening the screws. |
4. |
Install in the reverse order of removal. |
Rear Curtain Repair procedures
Inspection
Connect the battery voltage and check the rear curtain motor
rotation. If the motor does not operate properly, substitute with a
known-good rear curtain motor and check for proper op ...
Cleaning the interior window glass
If the interior glass surfaces of the vehicle become fogged (that is, covered
with an oily, greasy or waxy film), they should be cleaned with glass cleaner. Follow
the directions on the glass clea ...
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
Tightening torque :
2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft)
...