The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control module receives signal
from the sensor and restrains moisture and eliminate defog by
controlling the intake actuator, A/C, auto defogging actuator, blower
motor rpm, and mode actuator.
Inspection
1.
Turn the ignition switch OFF.
2.
Connect the GDS.
3.
Check the output voltage of AQS between terminal 2 and 3.
1. DC 12V( Ignition)2. Sensor ground3. AQS signal
Specif ...
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remov ...
See also:
Relay Box (Engine Compartment) Components and Components Location
Component Location
...
Tilt Steering/Telescope Steering
Adjust the steering wheel angle (2) and position (3) with the knob (1) on the
steering column. Move the steering wheel, so it points toward your chest, not toward
your face. Make sure you can ...
Snow tires
If you equip your car with snow tires, they should be the same size and have
the same load capacity as the original tires. Snow tires should be installed on
all four wheels; otherwise, poor handli ...