>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Sliding the Sunroof
The Engine Start/Stop Button must be in the ON position before you can open or
close the sunroof.
Pressing the sunroof control lever backward or forward momentarily to the second
detent posit ...
Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...
Description and Operation
Description
Active type ECS is applied and it includes the self leveling
function.As shown in the picture, it consists of air spring, damper,
reservoir tank, compressor (with dryer), solenoid ...