Hyundai Equus: ON/OFF Solenoid Valve Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Description and Operation
| Description |
ON/OFF solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears.
Damper Clutch Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resi ...
ON/OFF Solenoid Valve Specifications
Specifications
ON/OFF Solenoid Valve
x Control type : Normal low type
Control pressure kpa (kgf/cmx, psi)539.36(5.5, 78.23) Internal resistance(x)10~11
...
See also:
Hood Insulator Pad Repair procedures
Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
•
Be careful not to scratch the hood panel.
2.
Installation is the ...
Steering Angle Sensor Description and Operation
Description
Steering Wheel Angle Sensor detects rotating direction of the
vehicle. Rotating direction detected by the sensor is communicated with
HECU as CAN signal involving information about ...
Components and Components Location
Components
1. Rear bumper cover2. Rear bumper side bracket [LH]
...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com