>
Hyundai Equus Manuals

Hyundai Equus: Refrigerant Line Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Refrigerant Line Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Refrigerant Line Repair procedures

Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
   
Cap the open fittings immediately to keep moisture or dirt out of the system.
3.
Tighten the bolt or nut joint to the specified torque.
   
Connections should not be torque tighter than the specified torque.
4.
Evacuate air in the refrigeration system and charge system with refrigerant.
Specified amount:
700 ± 25 g (24.7 ± 0.88 oz.)
5.
Inspect for leakage of refrigerant.
Using a gas leak detector, check for leakage of refrigerant.
6.
Inspect A/C operation.
    Compressor oil Repair procedures
    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (P ...

    Compressor Description and Operation
    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low tempera ...

    See also:

    Pre-safe seat belt (PSB) (if equipped)
    The purpose of the pre-safe seat belt is to tighten the seat belt during emergency braking, or when a loss of control is sensed. CAUTION The pre-safe seat belt activates only when the passenge ...

    Mode Control Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...

    Hazard Lamp Switch Repair procedures
    Inspection 1. Check "IPM" input/output specification of hazard lamp switch using the GDS. If the specification is abnormal, replace the hazard switch module. 2. Select option "Input/output ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com