>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the BCM unit.
(Refer to Body Control Module - "Body Control Module") |
Installation |
1. |
Install the BCM unit. |
2. |
Connect the negative (-) battery terminal. |
Water pump Troubleshooting
Troubleshooting
Water Pump
SymptomsPossible CausesRemedyCoolant leakage
•
From the bleed hole of the water pump
Visually check
•
Check leaks after about ten-minute warming up.
•
If ...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly.
Allow adequate stopping distance because brake perfo ...
Height Sensor Repair procedures
Removal
[Front Height Sensor]
•
Avoid suffering excessive impact.
•
Do not entering the water into pin inside.
•
Take care not to be damaged height sensor witc ...