>
Hyundai Equus Manuals

Hyundai Equus: Fuel Pump Motor Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Fuel Pump Motor Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pump Motor Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pressure in Fuel Line"")"
3.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
4.
Remove the sub fuel sender.
(Refer to Fuel Delivery System - "Sub Fuel Sender")
5.
Disconnect the suction hose (A).
6.
Remove the head assembly (C ) after removing the fixing hook (B).

7.
Disconnect the dual hose (A).

8.
Release the fixing hook, and then remove the free filter (A) and fuel pump motor (B).

Installation
1.
Install in the reverse order of removal.
    Fuel Pump Motor Components and Components Location
    Components Pin NO.ItemDescription1Upper body3-phase coil power supply, fuel delivery, and sealing2Stator assemblyCreates an N pole and S pole flux to induce the rotor to turn.3rotor assemblyTorqu ...

    Fuel Sender Assembly Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. "Release the residual pressure in fuel line. (Refer to Fuel Delivery System -""Release Residual Pres ...

    See also:

    Coolant Repair procedures
    Engine Coolant Refilling And Bleeding     Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from ...

    ETC (Electronic Throttle Control) System Troubleshooting
    Fail-safe mode ITEMSFAIL-SAFEETC MotorThrottle valve stuck at 5°TPSTPS 1 faultReplace it with TPS2TPS 2 faultReplace it with TPS1TPS 1,2 faultThrottle valve stuck at 5°APSAPS 1 faultReplace it wi ...

    Brake Line Repair procedures
    Removal 1. Remove the wheel & tire. 2. Remove the brake hose clip (A). Front Rear 3. Disconnect the brake tube by loosening the tube flare nut. Tightening torque : 12.7 ~ 16.7 N ...

    Categories

    Hyundai Equus Manuals


    © 2011-2025 Copyright www.heqmanual.com