>
Hyundai Equus Manuals

Hyundai Equus: Heater Core Repair procedures - Heater - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Heater Core Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Heater Core Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
3.
Remove the heater core cover (A) after loosening the mounting screws.

4.
Pull out the heater core (A) from the heater unit.

   
Be careful that the inlet and outlet pipe are not bent during heater core removal/installation.
5.
Install in the reverse order of removal.
A.
If you're installing a new heater core, add refrigerant oil (PAG OIL).
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
D.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
E.
Apply sealant to the grommets.
F.
Make sure that there is no air leakage.
G.
Charge the system and test its performance.
H.
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
I.
Refill the cooling system with engine coolant.
    Heater Unit Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. When the engine is cool, drain the engine coolant fro ...

    Evaporator Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater unit lower case (A) after loos ...

    See also:

    Engine Control Module (ECM) Schematic Diagrams
    ECM Terminal And Input / Output signal ECM Harness Connector ECM Terminal Function Connector [C200-A] Pin No.DescriptionConnected to1Ignition Coil (Cylinder #3) control outputIgnition Coil ( ...

    Power Steering Gear Box Repair procedures
    Replacement 1. Drain the power steering fluid. 2. Remove the front wheel & tire. Tightening torque : 90.0 ~ 110.0 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft) 3. Loosen the bolt (A) ...

    Components and Components Location
    Component Location 1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. IPM (Instrument Panel Module) ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com