>

Hyundai Equus: Input Speed Sensor Description and Operation - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Input Speed Sensor Description and Operation

Description
Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transmission and delivers the readings to the TCM. The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

    Output Speed Sensor Repair procedures
    Inspection 1. Check signal waveform of output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

    Input Speed Sensor Specifications
    Specifications x Type: Hall effect sensor x Specifications Operation condition (°C)°F((-)40~150)) -40~302Air gap(mm)in.1.3(0.0512)Output voltageHigh1.4Low0.7 ...

    See also:

    Repair procedures
    Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Remove the front door module. (Refer to Body - "Front Door Module") 3. ...

    LDWS operation
    To operate the LDWS, pull the switch with the Engine Start/Stop Button in the ON position. The indicator illuminates on the cluster. To cancel the LDWS, pull the switch again. LDWS indicator li ...

    Puddle lamp
    When all the doors (and trunk) are locked and closed, the puddle lamp will come on for about 15 seconds if any of the below is performed. - When the door unlock button is pressed on the smart k ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com