Hyundai Equus: Tilting the Sunroof

To tilt the sunroof open:
Push the sunroof control lever upward to the second detent position. To stop
the sunroof tilting at any point, operate the control lever.
To close the sunroof:
Pull the sunroof lever downward until the sunroof moves to the desired position.
WARNING
- Make sure heads, other body parts or other objects are safely out of
the way before closing the sunroof to avoid injuries or vehicle damage.
- Never adjust the sunroof or sunshade while driving. This may cause loss
of vehicle control resulting in an accident.
- To avoid serious injury or death, do not extend your head, arms or body
outside the sunroof while driving.
✽ NOTICE
The sunroof cannot slide when it is in the tilt position nor can it be tilted
while in an open or slide position. After washing the vehicle or after a rain, be
sure to wipe off the water on the sunroof before operating the sunroof.
CAUTION
- Periodically remove any dirt that may accumulate on the sunroof guide
rail or between the sunroof and roof panel, which can make a noise.
- Do not try to open the sunroof when the temperature is below freezing
or when the sunroof is covered with snow or ice, the motor could be damaged.
In cold and wet climates, the sunroof may not work properly.
- To prevent damage to the sunroof and the motor, do not continue to press
the sunroof control lever after the sunroof is in the fully open, closed or
tilt position(s).
The Engine Start/Stop Button must be in the ON position before you can open or
close the sunroof.
Pressing the sunroof control lever backward or forward momentarily to the second
detent posit ...
If the battery has been discharged or disconnected, or if the related fuse has
been replaced or disconnected, reset the Sunroof as follows:
1. The Engine Start/Stop Button must be in the ON positio ...
See also:
Blower Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
3.
Separate the blower unit (A) from the heater un ...
Front Door Inside Handle Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Disconnect the front door inside handle lamp connector (A).
3.
After loosening the mounting screws ...
Relay Box (Engine Compartment) Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Pull out the relay from the engine compartment relay box.
Power Relay (Type A)
-
Do not use pliers.
...